This is an old blog that I started in 2006. I keep it because it has a lot of historical data and people still come here. As of September 2016, no new updates will be made here. All new blog posts and writing/publishing related news will be posted over on my new site at www.jenniferhudsontaylor.net.

Friday, January 14, 2011

Colonial Saw Mills & Lumber Mills


By Jennifer Hudson Taylor

By 1706 there were 70 saw mills operating in the #colonies. Large saws were used to cut wood into planks, boards, and veneers. Smaller saws were used to cut boards into smaller pieces, joints, and decorative objects.

Types of Large Saws

Single Sash - It was pulled downward by a waterwheell and upward by an elastic pole. Often, a waterwheel pulled the saw both up and down.

Parallel Saws or Gangs - Set in one frame so it can  cut several boards simultaneously.

Muley Saws - Had a lighter guiding mechanism for cutting wood.

Types of Small Saws

Ripsaws and Handsaws - Simple small blades with a handle that allowed men to cut through smaller pieces of wood by hand and mostly used for general purposes.

Cross-Cut and Pit Saws - Two-man saws that contained handles on each end for both men to operate tugging the saw back and forth through the wood. Logs were cut to length with these saws.

Backsaws - Contains a thin metal blade that is designed to make very fine cuts. A thick iron or brass strip fit on the back of the saw to make it more sturdy since the blade was so thin.

Compass Saws - Contained narrow, pointed blades to saw holes in the middle of wood.

Framed Saws - Blades were mounted inside wood. 

Felloe Saws - Were used by Wheelwrights and furniture makers to create curves in the wheels and the arms and legs of chairs and wood furniture.

Note: Several images of these saws are located at the Colonial Williamsburg link at the bottom of this page.

Before the Industrial Revolution, Oliver Evans developed a wood-burning, high-pressure steam engine that began to appear in saw mills by 1810. These engines allowed lumber to be manufactured without water power.

Since most saw mills operated by water wheel power, most were located on rivers or lakes. While some logs were shipped on long wagons by the load, many were simply thrown in the river and floated down stream to their destination. A logger's worst nightmare would be a log jam in the river. Many died trying to unjam the logs.

Sources:

1 comments:

I love this post, Jennifer! Very interesting and informative...of course I love historical information :) Thanks for sharing!

Blessings,
Penny